SUPERHERO FLASH FIGURE IRON ON TSHIRT TRANSFER

HERE WE HAVE A FAB IRON ON TSHIRT TRANSFER!

SUITABLE FOR USE WITH WHITE OR LIGHT COLOURED FABRICS ONLY

PRINTED ON AN A5 SHEET

GREAT FOR TSHIRTS, CURTAINS, MOUSE MATS ETC - THE LIST IS ENDLESS!

THEY ARE VERY EASYTO USE, I HAVE INCLUDED THE INSTRUCTIONS BELOW SO AFTER PURCHASE JUST VIEW THE PAGE & YOUR READY TO BEGIN!

Step 1; trim off any unprinted areas from around the image with scissors, leaving a narrow white border of about 2mm.

Step 2; set your iron to maximum temperature & preheat for 2 minutes (if using a steam iron set steam to off or as low as possible). DO NOT USE STEAM!!!

Step 3; Place a pillow case on a hard flat surface & then place the fabric for transferring on the wrinkle free pillow case (DO NOT USE AN IRONING BOARD!).

Step 4; Prepare the fabric for transfer application - iron area until flat & crease free.

Step 5; Place the transfer in the required position with the image facing down.

Step 6; you are now ready to begin. Start from a corner, press the iron over the image while applying weight pressure over it. Iron/press down for approx 10-15 seconds in each position over the whole image. (do not forget the steam nozzles….) taking particular care to press well over all edges & corners.

Step 7; remove the iron from the garment & allow the garment & transfer to cool.

Step 8;when & ONLY when cold, gently peel the transfer paper away from the garment.

Your image will now be on the garment & have a shiny gloss finish, - DO NOT LEAVE IT LIKE THAT! you need to fix the image to ensure the prolonged life of your transfer.

Step 1; cover the design with the sheet of white paper provided & iron evenly for 2-3 seconds max (do not put pressure on the iron, this needs to be a light touch). Peel the paper IMMEDIATELY WHILE HOT. (do not let it start to cool , do not take your time, get the paper off as quickly as possible. If these steps are not followed exactly the white paper will not peel from the transfer & your image will be ruined as the white paper will stick).

You will need to wash the garment prior to wearing/using - please allow 24-48 hrs after printing before washing the garment for the 1^st time.

For every wash turn garment inside out & machine wash at 40oc. Remove article as soon as the washing machine completes the cycle.

DO NOT; wash as delicate fabric.

DO NOT; hand wash or leave to soak.

DO NOT; dry clean or use bleaching washing powders.

DO NOT; iron over image.